Open the bomb bay doors using, and press. Select 4x500lb bombs from the Ordinance slot in the Ctrl-W parts menu. After the turn ensure the nose wheel is straight by taxiing forwards a few metres. The aircraft will pivot on the locked wheel and the nose wheel will caster. To make a full 180 degree turn, reduce speed to 10km/h, set idle throttle (G), turn fully to the left or right. As in real life, there is no nosewheel steering so wheel brakes are essential for turning at low speeds. Taxiing is accomplished by alternatively pressing T and G to keep speed below 50km/h.Try to avoid long periods of acceleration as the plane reaches high speeds fast. Once on the runway, press Z once to activate wheel brakes. Flare before touch down to avoid wheel or gear strut damage. If airspeed falls below 180km/h, press T to increase power, and then G again to resume gliding. Pull up to maintain a gradual rate of descent. When you are at the landing strip, press G till the engine reaches to 2k rpm to select idle throttle. This will slow the aircraft down to around 200km/h. Reduce power to 30% and when reaching 250 Km/h press N to extend the landing gearĪnd M for extending the flaps to landing position once. If you pull more than 4 G structural weakening will occur, and at 6G your wings will rip off. Instead, use half-strength control inputs (if using an XBox controller). Avoid full-deflection manoeuvring above 350km/h as this may result in structural damage. At speeds above 300km/h negative pitch will be necessary to maintain level flight. When the aircraft reaches 300km/h, it will fly straight and level without input. Once above 220km/h, raise the gear by pressing N. The aircraft will try to nose down with the gear extended due to drag. If using an XBox controller, pull the left stick down only half way to avoid a stall. Release the Brakes when the engine holds a steady Rpm.Īt 180km/h or above, pull up gently and take off. Then Throttle up with T while Holding Z to hold position(Rb when using an Xbox Controller). With the aircraft on the runway, Press M for Setting the flaps to takeoff position. When spawning look for the motor rpm to stabilize, if they are slowing down hold V to restart the engines. INFORMATION (please read before posting questions): added support for generic surface controller.added stall values and adjusted lift and drag.reduced instabilities and overall jbeam rework.added fuel tanks with variable amounts of fuel.Thanks to PrimeTheBomber for letting us use his liveries. Thanks to Diamondback, B25Mitch and others for helping to revive the B25.

Beamng drive boeing plane